The ANAN-8000DLE HF & 6M 200W SDR Transceiver meets and exceeds the requirements of even the most discerning Amateur Radio Operator, it is based on the work of the OpenHPSDR community.
Keeping in mind the various requirements posed by new cutting edge technologies implemented in the radio it has been designed from scratch, the design successes of the previous generation hardware has been improved in the new implementation.
The ANAN-8000DLE uses an entirely new redesigned transmit chain keeping in mind PureSignal (Predistortion), the result is astounding IMD performance, the typical transmit IMD distortion is about a 1000 times lower than that achieved by a typical modern transceiver available today. It is the world’s first Amateur Radio transceiver to use a 50v LDMOS device in the finals.
The ANAN-8000DLE includes two phase synchronous front ends to enable Diversity reception,
An internal four phase low noise boost supply is used to convert 13.8v to 50v for the finals, this enables the user to have the flexibility of using industry standard 13.8v DC as well as battery power whilst at the same time the radio provides all the advantages of the 50v LDMOS amplifier.
The front panel Display is microprocessor driven and displays all critical parameters such as Forward and Reflected Power, SWR, Current, Voltage, Temperature. The microprocessor also provides real time protection for all these parameters.
For more information, specification and to order:
Specifications:
General Specifications:
- Architecture: Direct Sampling DDC/DUC Transceiver
- Phase Noise (Clock): -149dB @ 10Khz
- Interface: Ethernet
- TCXO Stability (Typical): /- .1 PPM
- Modes: CW, SSB, NFM, AM, Digital
- Frequency Resolution: 1 Hz
- Antenna Ports: Three SO-239 50 ohms Software Configurable Ports, One BNC for RX2
ENLARGE PHOTO BELOW
Mechanical Specifications:
- 12Kg (approx. Weight)
- Dimensions: 483MM (L) x 123MM (H) x 320MM (D) (Not including extrusions)
- Stainless Steel Chassis and Aluminum Heatsink
Electrical Specifications:
- 13.8v DC @ 35A, 3A Receive/35A Transmit
Receiver Specifications:
- Receiver Architecture: Direct Down Conversion
- Dual 16 bit Phase Synchronous ADCs
- Independent filter banks for each ADC
- 10/6M LNAs
- Frequency Coverage: 9Khz to 60Mhz
- Attenuator: 1-30dB step attenuator
- Reciprocal Mixing Dynamic Range (RMDR): 116dB @ 2Khz
- Receiver Phase noise: -149dB @ 10Khz
- Image rejection: 100dB
- Hardware support for 7 independent receivers assignable to either ADC
Transmitter Specifications:
- Transmitter Architecture: Direct Up Conversion
- DAC Resolution: 16 bit
- RF Output Power: 1-200W SSB, CW, FM, RTTY, Digital; 1-50W AM
- IMD: IMD3 typically -72dB @ 200W output on 20M
- Harmonics: Typically better than -50dBc on HF and -60dBc on 6M
- Carrier and Opposite Sideband Suppression: Better than -80dBc
- Transverter IF Output: 0db to 15dB
IOs:
- RCA Line In, Line Out, PTT in, PTT Out
- DB9 Seven Software configurable Open Collector Outputs
- BNC XVTR TX Out, 10Mhz Reference Input
- 6.25mm Barrel Mic, CW Key, Headphones and Speaker Outputs
- SMA PureSignal (Predistortion) Loop Input and Output
- RJ45 Ethernet LAN Connector
Equipment
DV4home V2 The DV4home V2 is another member of the successful family of DV4 products. As usual it supports all digital modes, while simplifying and extending the supported functions. While it acts as a “home” for the DV... Read more
VHF
FTM-6000E – 50W transmitting power – Reception range from 108 to 999.995 MHz – New “E2O-III” user interface – Removable control panel AND Yaesu new analog dual-band FM vehicle transceiver for the 144 and... Read more
Recent Posts
Solar Storm Mania Makes Headlines
“According to many media sources, a massive solar storm is supposed to be ravaging Earth today. But the stories are overblown. Indeed a solar st... Read more
How To Build A QRP Dummy Load by K7AGE
“In this video, I build a simple QRP Dummy Load that is good for up to 20 watts. It even has test point that you can use a meter to measure the... Read more
National Parks on the Air (NPOTA) Map Now Available
In cooperation with ARRL, CQmaps has introduced a 2016 National Parks on the Air (NPOTA) map. The full-color map includes all NPOTA units, within the... Read more
How to Read Crossed-Needle SWR/Watt Meters
How to Read Crossed-Needle SWR/Watt Meters Read more
RadFxSat-2 Signals Detected, AMSAT Engineering Continues to Assess Status
by Paul Stoetzer On January 27th, Brad Schumacher, W5SAT, reported copying his CW signal weakly via the RadFxSat-2 transponder. On the morning of Janu... Read more
Solar Physicist Predicts a Slightly Better Solar Cycle 25
Solar physicist Leif Svalgaard of the W.W. Hansen Experimental Physics Laboratory at Stanford University has predicted a maximum sunspot number of 128... Read more
No Consensus Reached for FCC on “Symbol Rate” Issues
ARRL-initiated efforts for rival parties to reach consensus on some of the issues they raised in the so-called “Symbol Rate” proceeding have ended. In... Read more
