Ten-Tec PM1 QRP

Description

The MX1, AA1, VO1, and TX1 modules are wired into a band-switching 80-40 meter CW transceiver. Front panel controls: On-off, Transmit-Receive, Receiver Resonate, VFO-Crystal, Bandswitches, Oscillator tuning, Final Resonate. A meter is provided to monitor final amplifier current.

40-80 meters. 15 meter converter available.
Crystal control or transceive operation (Transceive on 40-80 meters, crystal only on 15 meters.)
Slide-rule dial. Flywheel tuning.
Power – 12 volt lantern battery.
Front panel band switching.
Shaped audio – 200-2500 Hz.
Metered power amplifier stage.
Silicon transistors. Integrated circuit.
2 KHz receiving band width
2 watts input to final stage
100 cycles drift. No warm-up.

Specifications

Frequency Range: 3.475 – 4.025, 6.975 – 7.325
Size: HWD 4″ x 10.125: x 7.5″
Shipping Weight: 4 lbs
Power: 12 volts. 20 ma on receive, 300 ma on transmit
Semiconductor devices: 1 dual gate MOSFET, 1 integrated circuit, 4 silicon transistors
Type of Reception: CW – SSB – AM
Sensitivity: Less than one microvolt provides readable signal
Antenna input: 50 – 75 ohms
Selectivity: 2 KC at 6 dB down points
Audio:Output impedance – 1000 ohms. Frequency response – +/- 3 dB 200 Hz – 2500 Hz
Frequency stability: Less than 100 Hz drift
Transmitter: Power – 2 watts input. Output impedance 50 – 75 ohms, fixed link
Headphones: Front panel tip jacks are provided
Key: Phono jack is provided on rear apron
Crystal: A crystal socket is provided on the front panel. The socket accepts holders of the HC6U type or any crystal with 0.486 inch spacing and 0.050 diameter pins.

Recent Posts

W6AM Don Wallace Museum Foundation donates to Northern California DX Foundation

June 01, 2016 in: News No comments

NCDXF Press Release, 30 May 2016 A donation of $29,000 on behalf of the Don Wallace Museum Foundation (DWMF) was recently given to NCDXF. After 30 years the DWMF is closing down, as the area of the famous W6AM Rhombic Ranch in Rancho Palos... Read more