GENERAL DESCRIPTION OF THE OM4000 HF POWER AMPLIFIER
The linear amplifier OM4000 HF is designed for all short wave amateur bands from 1.8 till 29 MHz (including WARC) and all modes. It is equipped with a two pieces of ceramic tetrode FU728F.
PARAMETERS:
Frequency Coverage: | Amateur Bands 1.8 – 29.7 MHz including WARC |
Power Output: | 4000W in SSB and CW, 3000W in RTTY, AM and FM |
Input Power: | Usually 60 to 90W for full Output Power |
Input Impedance: | 50 Ohm, VSWR < 1.5 : 1 |
Power Gain: | 17 dB |
Output impedance: | 50 Ohm unbalanced |
Maximum output SWR: | 2:1 |
SWR protection: | Automatic switching to STBY, when reflected power is 350W or higher |
Intermodulation distortion: | 32dB below nominal output |
Suppression of harmonics: | < -50 dBc |
Tubes: | 2x FU728F Ceramic tetrode |
Cooler: | Centrifugal blower + Axial blower |
Power supply: | 2 x 230V – 50 Hz one or two phases |
Transformers: | 2 pcs of toroidal transformer 3kVA |
Dimensions: | 485 x 200 x 455mm (width x height x depth) |
Weight: | 43 kg |
PROTECTIONS: | – VSWR too high |
– Input power too high | |
– Output power too high | |
– Plate voltage too low | |
– Anode current too high | |
– Screen current too high | |
– Grid current too high | |
– Mistuning of PA | |
– Hot switching protection | |
– Soft start for protecting your fuses | |
– “switch-on blocking “ at opened amplifier | |
BAR GRAPH INDICATORS: | – Power output – 50 LEDs |
– Reflected power – 20 LEDs | |
– Current at screen ( Ig2 –10 LEDs ) | |
– Anode voltage, anode current, tuning – 30 LEDs | |
LED indicators: | – current at control grid ( Ig1 – 2 LEDs ) |
– WAIT – preheating of tube (180 sec ) | |
– STBY – standby | |
– OPR – operating condition | |
– FAULT – failure, switching off for abt. 4 sec |
Photo´s
Warning: file_get_contents(https://plusone.google.com/_/+1/fastbutton?url=https%3A%2F%2Fqrznow.com%2Fom4000-hf-power-amplifier-4kw%2F): failed to open stream: HTTP request failed! HTTP/1.0 404 Not Found in /home/qrznow/public_html/wp-content/themes/goodnews5/framework/functions/posts_share.php on line 151