“The Green Egg for Ham is a cute name for a 3D printed cover for your NMO antenna mounts. The Motorola style NMO mount is a popular style mount for amateur radio antennas. And you’ll want to keep your mount covered or capped if you don’t have an antenna on it. Otherwise you run the risk of water leaking into the mount and causing all sorts of problems.
The Green Egg for Ham is a fun way to do that. The cover is about 2.5 inches tall by 2 inches wide and is threaded so it can screw onto the antenna mount. It should provide waterproof protection of your antenna mount while being a little whimsical at the same time. General 3D Green Egg for Ham: http://www.general3d.com“
There are a number of ways that you can adjust your transceiver for optimum receive performance Read more
Connections are as follows: antenna via 50 ohm BNC, power via 2 pin 0.1″ header, headphones via 3.5mm mono or stereo jack plug or 2 pin header,... Read more
Messi & Paoloni – Notwithstanding its small dimension (7,3 mm) its performances are so good to outperform RG 213/U (10,2 mm) and put into sh... Read more
Ameritron mobile no tune Solid State Amplifier –Mobile no tune Solid State Amplifier – uses four rugged 2SC2879 high power linear RF power... Read more