CS108G+ HF Radio [ Pre-Order ]

CS108G+ is an upgraded version of the X108G from Xiegu. Besides the standard features as will be described below, this version has a built in Spectrum Analyzer and ID timer. The CS108G is a single-conversion HF transceiver. Its receiver is optimized for DXing by having a very low noise front end and a built in Pre-Amp. The radio comes standard with a 2.3k SSB and 500Hz narrow-band CW filter. The filters excellent properties dramatically improves the overall performance. The machine has a large dynamic range AGC control so the radio can properly process both weak and strong signals. in addition it also has S meter, power meter, NB capabilities, and many other features to meet the daily needs of most operators. To optimize the radio for outdoor use, the radio is equipped with a color OLED solid state display which allows you to clearly see the viewing content in both bright sunlight and at night.

Features

1.    Low noise, single-conversion super heterodyne receiver.
2.    Double-balanced diode mixers provide excellent dynamic range
3.    Receiving sensitivity: 0.25uV(preamplifier open,> 1.8MHz band).
4.    Narrow double-tuned band-pass filter covering the all amateur bands (WARC bands).
5.    Built NC APC circuit, allows variable constant power output.
6.    Standard 0.5ppm TCXO circuit allows accuracies of a few hertz over all bands.
7.    Standard narrowband 500Hz CW filter.
8.    Built in Spectrum Analyzer

Basic parameters

Frequency Range: Receive: 0.5 ~ 30MHz
Emissions: All HAM bands
   SSB (J3E)
   CW (A1A)
   AM  (A3E)
Minimum frequency step: 1Hz
Antenna Impedance: 50Ω
Operating temperature range: -10 ℃ ~ + 60 ℃
Frequency stability: ± 0.5ppm after 5 minutes
Operating voltage: 12 ~ 14.5V DC
Operating current: 600 mA Max Receiver, 7.5 Amps Transmit 7.5A
Max Machine size: 120 * 45 * 180 (mm) [not including knobs, handles, andconnectors]
Transmitter parameters

Transmit power: 20W (@ 13.8V)
Modes: SSB Upper Sideband
            SSB Lower Sideband
            AM
Spurious rejection: ≥40dBc
Carrier suppression: ≥45dBc
Selectivity: SSB 2.4kHz (-6dB)
                 CW 500Hz (-6dB)
Receiver parameters
IF frequency: 10.7MHz
Receiving sensitivity:
0.5uV (PRE ON, ≤ 2.0MHz)
0.3uV (PRE ON, > 2.0MHz)

Ham bands:

1.8   ~ 2.0MHz
3.5   ~ 4.0MHz
5.0   ~ 5.5MHz
7.0   ~ 7.3MHz
10.0 ~ 10.2MHz
14.0 ~ 14.5MHz
18.0 ~ 18.2MHz
21.0 ~ 21.6MHz
24.8 ~ 25.0MHz
28.0 ~ 28.8MHz
0.5   ~ 30.0MHz (Can transmit on ham bands only)
Dynamic range: better than 90dB
RIT frequency tuning range: ± 1kHz
Audio output: 0.5W@8 ohm

$520.00

VHF

Tytera TYT TH-8600 Dual Band Mini Mobile Two Way Radio

October 04, 2016 No comments

The TH-8600 is a powerful dual band, dual display and dual standby transceiver with 20 watts of power on 400-470MHz UHF and up to 25 watts on 136-174M... Read more

BaoFeng Tech BF-F8HP

November 14, 2014 No comments

BF-F8HP: “BaoFeng’s Only TRI-POWER (1, 4, 8 Watt)” ExClusive Features that separate it from the UV-5R Series: It has 3 Power Levels... Read more

Alinco Released a new radio Today – DJ-R200D

December 05, 2016 No comments

Alinco Corporation December 6, 2016, announced the latest model of the 420 / 440MHz band specified low-power handheld machine equipped with a super mu... Read more

SAMCOM Mini Mobile Radio 218

November 10, 2015 No comments

SAMCOM Mini Mobile Radio 218 Key Specifications Frequency Range V:136.000MHz-174.000MHz V:220.000MHz-248.000MHz U:400.000MHz-470.000MHz System F3E(FM)... Read more

Kenwood TM-D710GA

February 26, 2015 No comments

Specifications Covers 144-148 and 430-450 MHz transmit with 118-524 MHz (Band A) 136-524 MHz and 800-1300 MHz (Band B) less cellular receive Du... Read more

App - Mobile

Morse Intercom – APP

September 08, 2015 No comments

Features:i) Send Morse to, and receive Morse from, other users of the app. Restrict usage to your WiFi network, or allow full Internet connecti... Read more

RUMlogNG2Go for iOS version 3.3 now available

February 03, 2017 No comments

Thomas Lindner, DL2RUM, is happy to announce the availability of version 3.3 of his RUMlogNG2Go logger for the iPhone and iPad. RUMlogNG2Go can be do... Read more

AmsatDroidFree now open source

January 30, 2018 No comments

AmsatDroidFree satellite tracking App for Android devices is now open source. This App predicts future passes for amateur radio satellites for a speci... Read more

SmartSDR for iOS v2.1.0 Now Available

August 25, 2017 No comments

FlexRadio Systems announces the release of SmartSDR for iOS v2.1.0 is now available for download or update from the Apple App Store. This App requires... Read more

EchoLink for iOS version 2.6.14 is now available

March 13, 2018 No comments

EchoLink for iOS version 2.6.14 is now available in the App Store. This is a 64-bit build that is fully compatible with iOS 10 and modern iOS devices.... Read more