Codan Envoy
- Channels and ScanningUp to 1000 simplex or semi-duplex. Up to 20 scan groups. Simultaneous scanning for Selcall (ALE/CCIR) and voice. Dwell time 125 ms to 9.9 s, adjustable
- Contacts ListUp to 500 entries
- SDR processing architectureDSP: 456 MHz, 32-bit
FPGA: 500,000 gate
MCU: ARM9, 300 MHz 32-bit
- InterfacesUSB (via Handset or Console)
Serial RS232 (supports NMEA-0183 GPS)
Ethernet (TCP/IP, supports remote control)
Auxiliary GPIO (audio in/out, PTT, RS232) on Envoy™ X2 model - Audio responseLess than 3 dB variation from 300 Hz to 3 kHz (with optional 2.7 kHz filter)
- ComplianceCE, FCC, IC, AS/NZS 4770:2000, AS/NZS4355:2006
- Temperature range and Humidity–30 to +60°C; 95% RH maximum, non-condensing
RF
-
Frequency range
Transmit:
1.6 to 30 MHz
-
Receive:
250 kHz to 30 MHz
-
Frequency Stability:
±0.3 ppm from –30°C to +60°C
-
Modes
Single Sideband USB, LSB (J3E), AM (H3E), CW (J2A),
AFSK (J2B), FSK (F1B), Software Defined -
Output power
125 W PEP ±1 dB (two-tone or voice), user-programmable in 1 W steps (low/medium/high)
-
Duty cycle
100% Voice/Data with optional fan
-
RF output impedance
50 Ω
-
Filter bandwidths
2.4 kHz standard (500 Hz, 2.7 kHz, and 3 kHz optional)
-
Transmitter specifications
Spurious and harmonic emissions:
Better than <69 dB below PEP
- Intermodulation products:40 dB below PEP
- Carrier suppression:Better than 65 dB below PEP
- Sideband suppression:70 dB below PEP
-
Receiver specifications
Sensitivity:
0.12 μV, –125 dBm for 10 dB SINAD
- Selectivity:>70 dB at –1 kHz and +4 kHz ref SCF USB
- Blocking:>100 dB at ±50 kHz
- Image rejection:>95 dB
- Spurious response:>85 dB
- Intermodulation:Unwanted signal >92 dB below desired signal
- Intercept point:+38 dBm
-
Switching speed
<25 ms (Tx:Rx or Rx:Tx)
ELECTRICAL
-
Operating range
10.8 to 15 V DC (12 V Nominal)
-
Supply current
Rx: 500 mA (backlight min, audio muted)
Tx: Two-tone 12.5 A typical, average speech 8 A
-
Protection
Over-voltage/under-voltage/over-temperature/reverse polarity
MECHANICAL
-
Size
2210 RF Unit:
210 x 270 x 65 mm (8.3 x 10.6 x 2.6 in)
- 2220/1 Handset:75 x 32 x 151 mm (3.0 x 1.3 x 5.9 in)
-
2230 Console:
190 x 228 x 79 mm (7.5 x 9.0 x 3.1 in)
-
Weight
2210 RF Unit:
2.8 kg (6.2 lb)
- 2220/1 Handset:0.3 kg (0.7 oz)
- 2230 Console:1.1 kg (2.4 lb)
-
Paint finish
2210 RF Unit:
Powder-coated matt black
-
Ingress Protection
IP43, MIL-STD-810G method 510.5
-
Environmental standards
MIL-STD-810G (Dust, Shock, Vibration, Humidity, Fungus, Altitude)
ACCESSORIES
-
500 W / 1 kW High Power Amplifiers
-
3040 Automatic Whip Antenna
-
3033 Telephone Interconnect
-
3020 AC Mains Supplies
-
Dual-port Antenna Selector
-
Vehicle Installation Kit (including dash-mount)
See More:Link
More
Belka-DSP radio receive
The Belka-DSP radio receiver is designed to receive radio stations with amplitude, frequency and single-band modulation, as well as telegraph signals... Read more
144 MHz filter stops interference
Designed and manufactured by SOTABEAMS, this neat bandpass filter is for use with handies (HT) in areas with multiple transmitters. In such areas, man... Read more
First KX3 with PX3
“I’m trying out the first KX3 with PX3 retrofit. It is big, but it looks really nice and sounds amazing! Cost for parts, labor and US ship... Read more
Mercury III LDMOS Power Amplifier Kit
Mercury III https://www.km3km.com/ Read more
Parametric Receive Audio System Equalizer – Heil Sound
The Heil Parametric Receive Audio System Equalizer (PRAS EQ) is a state-of-the-art audio processor that enhances the internal audio systems of amateur... Read more
NanoVNA a $50-$70 Ham Radio Antenna Analyzer?
AURSINC Vector Network Analyzer 50KHz -900MHz HF VHF UHF Antenna Analyzer Measuring S Parameters, Voltage Standing Wave Ratio, Phase, Delay, Smith Cha... Read more