AnyTone AT-5555N

GENERAL SPECIFICATIONS

Frequency Coverage: 28.000 to 29.699 Mhz
Antenna Impedance: 50 ohm, unbalanced
Frequency Control: Digital Phase-Lock Loop (PLL) Synthesizer
Frequency Accuracy: Better than +10 ppm from 0 – 40 °C after 15 min. warm up
Power Requirement: 12 -13.8 V DC, negative ground
Current Consumption: 7 amps maximum
Dimensions: 6 x 2 x 9.5 in (W x H x D)
Weight: 2.9 Ibs

TRANSMITTER SPECIFICATIONS
Power Output: SSB/ FM…30 Watts, …AM..10 Watts RMS / 30 Watts PEP
Tuning Steps: 10/100hz /1 kHz /10 kHz,100khz,1Mhz
Final Transistors: IRF520 MOSFET (x2)
Spurious Emissions: More than 50 dB below peak output power
Carrier Suppression: More than 40 dB below peak output power
Unwanted Sideband: More than 50 dB below peak output (1 kHz tone)
FM Deviation: +/- 5 kHz maximum
Audio Response: More than 30dB below peak output
Frequency Response: 400 to 2800 Hz
Microphone Impedance: , 600 to 1 K ohms

RECEIVER SPECIFICATIONS
Circuit Type: Dual-Conversion Super-heterodyne
Intermediate Frequencies:
1st IF/SSB IF…10.695 MHz
2nd IF…455 kHz
Sensitivity:
SSB…0.25 V at 10 dB S + N/N
AM…1.0 V at10dBS+N/N
FM…0.3 V at12dBSINAD
Selectivity:
SSB…4.2 kHz (-6 dB) / 8.5 kHz (-60 dB)
AM / FM…6.0 kHz (-6 dB) /18 kHz (-60 dB)
Clarifier Range: +/-1.5 kHz
Adjacent Channel Rejection: Better than 70 dB
I F Rejection: Better than 85 dB for all frequencies
Frequency Response: 250 to 3000 Hz

Audio Output Power: 2 watts minimum at 10% THD with an 8 ohm load
Audio Output Impedance: 8 ohms
RF Power Output 30W SSB (pep)/ 10W AM (rms)/ 30W FM (rms)

Dual Finals on Heat Sink
Modes AM, FM, USB, LSB
Microprocessor Controlled
6 memories
Frequency Scan
Variable RF Output Power all modes
6 Digit LCD Frequency Display

Scanning Microphone step in 1/5/10/100khz steps
Night Illuminated Display – Buttons are not
Surface Mount Technology throughout
Dimensions 2(H) x 6(W) x 9.5(D) in