We are excited to introduce our brand-new AMP-25 amplifiers!
The AMP-25 series do more than just amplify a signal, they also purify your signal as it passes through! We are also thrilled to present a whole new way to connect with amplifiers, allowing you to use a handheld mic and built-in speaker – just as if it were a mobile or base radio (but at a significantly lower cost).
An intelligent handheld radio companion:
A new and easy way to get the most from your radio, this is not your grandpa’s amplifier.
Output of 20-40W (from 2-6W input).
Works with most FM analog and digital modes (even including DMR!)
Transmit a cleaner output signal produced by your handheld radio.
Multiple ways to connect and use your handheld from a vehicle (or field) environment – without programming a duplicate radio.
What is it?The BTECH AMP-V25 amplifier is a portable, lightweight, wide coverage RF power amplifier for handheld radio equipment and is equally capable of amplifying both analog and digital signals.
Pair with the UT-72 Antenna for easy installation to your vehicle, or connect to another VHF base, mobile, or field antenna.
Supported Amplification Modes :The AMP-V25 operates from 136-174 MHz and can be used for analog FM, P25 Phase 1, C4FM (System Fusion), NXDN, IDAS, dPMR, and MPT1327 modes.
The AMP-V25 supports out-of-band transmitting, while the amplifier is turned off, allowing you to quickly transmit on a UHF signal without disconnecting your radio – but simply turning it off. When transmitting out-of-band the amplifier will pass-through the signal without amplification.
Built In Loud-Speaker :When you connect your handheld radio with the radio control cable; the amplifier will use it’s own loud 4W built-in speaker to broadcast the incoming audio.
“Always great to see Ray Novak at every hamfest I attend. This year was at the Huntsville Hamfest 2021. A lot of people are eagerly waiting for... Read more
Hytera, a leading global provider of innovative professional mobile radio (PMR) communications solutions, officially launched its highly anticipated L... Read more
Great news for digitally connect hams in the great Toronto area! Today, VA3XPR launches an all-digital repeater using Yaesu’s System Fusion C4FM FDMA... Read more
TI-3000 RigExpert TI-3000 is a new and powerful USB transceiver interface based on high-quality stereo codec IC, for operating phone, CW and digital m... Read more
This video briefly shows how to setup and use the NanoVNA to sweep an antenna system (antenna, transmission line, transmatch, etc.) to measure its VSW... Read more
Amateur Radio operators have relied on the RF-PRO-1B Active Magnetic Loop Antenna for decades. Now, it is manufactured and sold exclusively by DX Engi... Read more
Horizontal and elements rod kit On the models with 4 and more elements, we use an horizontal tie-rods kit, to prevent bending in the horizontal plane.... Read more
This 4th version of the QRP UltraLight MLA antenna has the same foldable construction designed for easy carry in a common laptop bag same as the 3rd v... Read more
FT8 is a mode in the WSJT-X software developed by Dr Joe Taylor K1JT. In this video I show how to get started and make contacts with FT8, introduction... Read more
“Dear WSJT-X and MAP65 Users, We are pleased to announce that a public Release Candidate WSJT-X 2.5.0-rc4 is now ready for download by beta testers. O... Read more