Dave Bernstein reported this on the DXLabs support group today:
ADIF 3.1.0 was approved today:
ADIF 3.1.0 specifies that the representation for FT4 is an ADIF record is
This is the representation used in the current version of DXKeeper (14.9.2) when exporting an ADIF record. When importing an ADIF record, DXKeeper interprets both
to mean “QSO mode is FT4”.
As the software sages say, “Be precise when exporting, but tolerant when importing”.
https://www.youtube.com/watch?v=TgAkcmd7ixA Read more
The Federal Emergency Management Agency (FEMA) has announced that two 60-meter channels have been made available, as necessary, for interoperabil... Read more
Comparing The ICOM IC-705 HF QRP & ICOM IC-7300 Transceivers Read more
The FCC has granted ARRL’s request for a temporary waiver to permit amateur data transmissions at a higher symbol rate than currently permitted by sec... Read more
The Hurricane Watch Net (HWN) just stood down from another extended session — 71 hours of continuous operation — for Hurricane Paulette and Hurricane... Read more
The Engineering Model, the first development model, of the NANOMIRAX / CRON-1 nanosatellite carried out its environmental testing campaign at the Inte... Read more