All features of MFJ IntelliTuners– Ultra-fast, Safe Automatic Tuning . . . Wide Tuning Range (12-1600 Ohms from 1.8 to 30 MHz ) . . . Radio Interfaces . . . Built-in Antenna Switch for two coax/long wire . . . Automatic Bypass protects your amplifier . . . Field Upgradeable Software . . . Very Compact!
The MFJ-998 Full Legal Limit 1500 Watt Intellituner takes you to the final level in automatic antenna tuners. With a capability of 1500 watts SSB and CW, coupled with automatic tuning, your high-power station can now operate essentially hands-free even when frequency and band changes are made.
Fast Automatic Tuning
The MFJ-998 instantly matches impedances from 12-1600 ohms using MFJ`s exclusive IntelliTune, AdaptiveSearch and InstantRecall algorithms with over 20,000 VirtualAntenna Memories. When you key your transmitter, MFJ`s InstantRecall checks to see if that frequency has been used before. If so, tuning is instantaneous. If not, MFJ`s IntelliTune algorithm (based on MFJ`s efficient SWR Analyzer technology) measures the impedance, snaps the necessary components in place, and then fine-tunes the SWR. If the antenna impedance is outside the tuner`s measurement range, MFJ`s Adaptive Search algorithm measures the frequency and determines only relevant component values — which are then searched for fast tuning.
Safe Automatic Tuning and Amplifier Protection
The MFJ-998 includes MFJ’s Amplifier Bypass Control — an MFJ exclusive feature! When used with a transceiver interface cable, tuning is safe and “stupidproof”! When a tuning cycle is initiated, the MFJ-998 first bypasses any in-line amplifier. Next, the MFJ-998 initiates a low-power CW tuning carrier from your transceiver. When tuning is complete, the MFJ-998 reverts your transceiver to its prior power and mode, and re-enables the amplifier. This entire cycle typically takes less than a second! Finally, if the MFJ-998 cannot find a match better than a preset amplifier SWR trip-point, the amplifier stays bypassed to provide automatic SWR protection for your amplifier — another MFJ exclusive!
A large analog Cross-Needle SWR/Watt-meter displays selectable 300/60 watt or 3000/600 watt forward/reflected full-scale ranges. You can even select automatic power ranging — the best power range is automatically selected for you.
Digital LCD SWR/Wattmeter
A two-line, 16-character backlit LCD meter displays SWR, forward/reflected power, frequency, antenna selected, an auto-ranging bargraph power indication,
and much more. You can even read the final matching inductor and capacitor values should you want to build your own fixed matching network. Simple menus
determine displayed information – no complex button combinations to remember!
MFJ VirtualAntenna Memory
MFJ new VirtualAntenna Memory system gives you 4 antenna memory banks for
each of 2 switchable antenna connectors. Select up to 4 antennas on each antenna connector. Each antenna has 2500 memories, 20,000 total. Has two coax connectors and a binding post for end-fed long wire antennas.
Download and Upgrade Remotely
Field upgradeable firmware via the serial port — download and upgrade your MFJ-998 as new features are introduced!
Plus Much More!
Built-in radio interface provides control of most amateur transceivers.
Automatic bypassing when excessive tuning power or power in excess of 1500 watts is applied.
Use balanced line antennas with external MFJ-912, 1.5 kW 4:1 balun.
MFJ-998 is the smallest full legal-limit auto-tuner in the world! 13Wx4Hx15D
inches fits easily into your ham station. Weighs just 8 pounds — great portability! Requires 12-15VDC at 1.4 amps maximum or 110 VAC with MFJ-1316.
Pre-wired Rig Interface
Cables for MFJ-929/998
MFJ-5114K Prewired Rig Interface cable for Kenwood and compatibles.
MFJ-5114I. Prewired Rig Interface cable for Icom and compatibles.
MFJ-5114Y. Prewired Rig Interface cable for Yaesu and compatibles.
MFJ-5114Y3. Prewired MFJ-929 to FT-1000MP, FT-9000 Yaesu rigs.
MFJ-5114Y4. Prewired MFJ-929 to FT2000 Yaesu rigs.
Description Functional overview of the application DR functions You can use some transceiver’s DR functions. Share pictures Send and receive vo... Read more
This app answers the two basic questions facing radio amateurs:- Which band shall I use ? Where shall I point my beam ? It will be of interest to an... Read more
“This video is a quick tour, but complete, of the Kenwood TH-D74. If you have any questions or comments, don’t hesitate to ask via the comments... Read more
“I’m currently testing a new software for the DV4home. The modifications included, the DMR+ complete masters list, the Brandmeister reflec... Read more
The MULTI BEAMING Open STACK controller by RemoteQTH.com is the black box designed to controll the stack match as the multibeaming switch. You can e... Read more
These tests show that the signal strength of a local station can be many tens of decibels weaker than from a DX station. For the last several years I... Read more