A cross-country, station-hopping relay this month recreated the January 27, 1917, route of the first formal Amateur Radio transcontinental message traffic bound for ARRL Headquarters. This method of traffic handling is in the DNA of the then-nascent national organization for Amateur Radio’s name — American Radio Relay League. Kent Trimble, K9ZTV, organized the January 27 commemoration, in which a message originating at W6UE, the Cal Tech club station in Los Angeles, hopped to K8ZTT in Denver; to W9ABD in Jefferson City, Missouri; to KT2D in Albany, New York, and finally to W1AW. The message was addressed to ARRL CEO Tom Gallagher, NY2RF. The commemorative event chose 160 meters, as it was the band closest to the 200-meter wavelength used for the original accomplishment.
“The spirits of 6EA 9ZF 9ABD 2AGJ and 1ZM send commemorative greetings on the 100th anniversary of first transcontinental relay of formal message traffic 73,” read the message, which, for a signature, included the call signs and locations of the stations involved in the relay.
As Trimble reported, the message originated at W6UE at 0801 UTC and followed the same path of the 1917 message relay. “Despite deep QSB, persistence paid off with Bob Dillon, KT2D, confirming receipt before completing the route to W1AW at approximately 0930 UTC,” Trimble recounted. That was 4:30 AM in Connecticut.
“Great work, all, especially W9ABD’s patience working through the QSB and QRN on the long Jefferson City-to-Albany leg,” Dillon said. W1AW Station Manager Joe Carcia, NJ1Q, reported that copy on KT2D was fair, with some troublesome noise and fading.
In 1917, two messages originated by the Seefred brothers to ARRL President Hiram Percy Maxim and one from Lindley Winser to ARRL Co-Founder Clarence Tuska were relayed from 6EA in Los Angeles to Capt. W.H. Smith, 9ZF, in Denver, to Willis P. Corwin, 9ABD, in Jefferson City, to Kenneth Hewitt, 2AGJ, in Albany, and finally to Maxim’s 1ZM in Hartford, Connecticut. The routing for this month’s commemorative event was identical to that of a century earlier.
The very first effort to move formal message traffic via Amateur Radio from coast to coast, on January 4, 1917, “was broken up by static,” according to an account in Two Hundred Meters and Down, by Amateur Radio historian Clinton DeSoto, W9KL.
DeSoto said the January 27, 1917, triumph, in which three messages were relayed across the US, was topped a few days later on February 6, when a piece of traffic originating on the East Coast made its way to the West Coast, with a reply reaching the East Coast all within 1 hour and 20 minutes.
“This marks the first real Amateur Radio communication with a definite address,” noted an article, “Trans-continental Traffic Begins,” trumpeting the January 27, 1917, accomplishment in the April 1917 issue of QST. “We are told that broadcast messages have been put across [the country] before, but it is an altogether different thing to get something across by luck, trusting to any station who may happen to hear it, and to handle a message to a definite address through definite relay stations.”
In 2007, the Mid-Missouri Amateur Radio Club in Jefferson City, Missouri, observed the 90th anniversary of that historic night with a special event honoring the then-teenaged Willis P. Corwin, 9ABD, the operator at that second point in the relay in 1917. W9ABD today is the call sign of the Corwin Heritage Amateur Radio Club in Jefferson City.
“We set up within feet of his original spark-gap shack,” Trimble recounted in a 2008 Electric Radio article, “and the mayor of Jefferson City dedicated a plaque on that site in his memory.” Corwin died in 1959, on the 42nd anniversary of the January 27, 1917 milestone.
Source:ARRL
Antenna
The Mighty Rhombic, the King of Antennas
“There was a time, back in the 1930s and 1940s, when the rhombic antenna was the king. A remarkable antenna that had phenomenal directivity and... Read more
8.5 DB gain for less than $40.00 – 50MHz Yagi
by W3GAS The Yagi is one of the simplest directional antennas you can build today. There are no moving parts, and the Yagi can be matched to 50 OHM v... Read more
Lesson 6.1 Antenna Basics
Antenna Basics “General Class Ham Radio instructional video, introduces Section 6.1 in the ARRL General Class License Manual. The section is ext... Read more
2m Yagi Beam Antenna | 144 MHz 10 Element Super-Light High Gain OWL G/T
OWL G/T Yagis Beam Antenna are specialized, ‘hot rod’ versions of the already high-performance OWL – Optimised Wideband Low impedan... Read more
Comet GP-15 Tri-Band VHF/UHF Base Vertical Antennas GP-15
Comet GP-15 Tri-Band VHF/UHF Base Vertical Antennas provide good gain figures on the 6-meter, 2-meter, and 70-centimeter bands in a compact 7.9 foot p... Read more
VHF
YAESU FT-60R
YAESU FT-60R Yaesu’s newest 144/430 MHz 5-Watt FM Hand-held was introduced at Dayton 2004. The FT-60R includes wide receiver coverage, outstandi... Read more
Icom Launch New IC-A220T 8.33kHz Air Band Panel Mount VHF Radio
The IC-A220T, Icom’s next generation 8.33kHz* air band panel mount transceiver, is now TSO / ETSO approved** and available for sale. The long awaited... Read more
TYT DM-UVF10 GPS DPMR Digital Transceiver VHF + UHF
TYT DM-UVF10,a dualdisplay, dual standby two-way radio,adopts high-technology and novel design DM-UVF10 adopts humanism design,making it smart in sh... Read more
ICOM ID-51A-PLUS2 Handheld Transceivers
ICOM ID-51A-PLUS2 Handheld ICOM ID-51A-PLUS2 Handheld Transceivers offer global D-STAR connectivity! These dual band transceivers have a super-compa... Read more
Portable Repeater Controller
This microprocessor-based Portable Repeater Controller was designed to quickly build a fully functional repeater ‘in the field’ in less th... Read more
Equipment
Antennas and bands programmable controller LBC8ARD – MomoBeam
LBC8ARD 8 DIRECTION CONTROLLER programmable for any remote relay switches and controlers; Easily programmable to control equipment of: LowBandSystems... Read more
Coax Cable Stripping Tools
Coax Cable Stripping Tools DX Engineering DXE-UT-8213LR Coax Cable Stripping Tools have been designed to properly prepare coaxial cable for use... Read more
OM4001A – OM POWER amflifier – 4 KW
OM4001A General description and the advantages of the OM4001A amplifier The OM Power model OM4001A is an automatic power amplifier, designed for use o... Read more
COMET ANTENNA ANALYZER CAA-500MARKII
CAA-500MARKII The NEW CAA-500MARKII SWR/Impedance Analyzer is finally arriving from the Comet factory! The new analyzer retains the same analog cross... Read more
HF Linear 2KW HF2015DX – Chinese
HF2015DX RF Linear amplifier coverd 1.8-30MHz amateur band , using Chinese FU728F ceramic tetrodes working at Class AB1 Input:30-40W output:2000W... Read more
Digital Modes
Second Public Test of FT8 DXpedition Mode Demonstrates High Contact Rates Possible
The second public test of FT8 DXpedition Mode has shown that the mock DXpedition stations (“Foxes”) were able to work the pileups of callers (“Hounds”... Read more
New Ham Shack Part 4, Audio Mixer Installation by K7AGE
In this video I show you how I setup an audio mixer for my ham radio station. I am using this mixer to monitor the audio outputs from my Elecraft K3,... Read more
Getting Started on FT-8 by Jim Heath W6LG–Using Holiday Lights
“An amazing new mode for quickly communicating around the world with low power and simple antennas. In this video Jim uses exterior holiday or C... Read more
Ham Radio HF Digital Modes: Hellschreiber, Feld Hell Tutorial
“Are you tired of PSK31? Are you sick of FT8? Is RTTY just a bunch of contesting anymore? At last, I finally finished this video and started ano... Read more
FT8CALL – The NEWEST HF Digital Mode, Introduction and Demo
FT8CALL “FT8, as we know, has dominated the airwaves for over a year now. Imagine the ability to have keyboard to keyboard ragchew, with... Read more