The Cobweb 2000
The 5 bander CobWeb Antenna is a High Quality designed antenna with products from Europe. We don’t use low-budget accessories. This Cobweb Antenna is using a double 1:4 balun that can handle a little more then 2 KWatt, also the wire’s can handle the load of high powered stations.The design is the same as the low power Cobweb Antenna only using other materials to handle the load. The Antenna is in size 2.6m x 2.6m and has a total size of 6.76m².
Our #1 priority is you, the radio Operator. We believe in our product and hold ourselves to the highest standards. We truly care about your antenna needs as much as you do, which is why we offer the best Quality used in creating and constructing the cobweb antenna.
Looking for a great antenna and you do not have the space ? The Cobweb is the solution, Great antenna for small places !
Only High Quality Materials made in Europe
Only HIGH QUALITY European products are used in the design of the CobWeb Antenna. Full IP67 with Scotchcast 40 inside the feedbox.
ToroidFor the balun we use a water sealed feedbox from Velleman with inside a double Toroid Core TX36/23/15-4C65 from Feroxxcube for the 500Watt version . As for the High Power version we use a double TX58/41/18-4C65 from Ferroxcube.
The mounting consist of 2 aluminium plates 0.5 Cm thick, pre-drilled
Inox Screws and Lock Nuts
The Used material for the screws and locking nuts is INOX to prevent rust.
The Antenna wire we use depends on the version of the Cobweb Antenna. We are using thinner wire for the low power version and thicker wire for the high power version. The wires are coated with a UV resistent coat.
The Feedbox is pre-made with a ferroxcube toroid, clamps, IP67 sealed with 3M coatingZig-Zag Connector
Instead of using tie wraps to keeps the wires in place we use a UV resistent Zig-Zag Connector allready mounted on the spreaders, just fold the antenna wire between the connectors. The wire is also marked so you don’t have to measure anything.
UV resistent clamps to hold the rods in place
The spreaders are from Glass Fiber in a yellow jacket, diameter of 10mm and a weigh of 143gr/m
3M™ Scotchcast™ 40 Premium Resin is a premium 2 part polyurethane designed for electrical insulation and mechanical protection. The resin once hardened provides impact resistance and durability against moisture and atmospheric corrosion
See More :
Diamond Antenna SG2000: 144MHz(2m) Length:1.59m / Weight:400g Gain:5.2dB / Max.power rating:150W / Impedance:50ohms VSWR:Less than 1.5:1 / Conn... Read more
Country in Europe increase 2 more new HF bands on amateur radio Radio amateurs in Latvia now have two new bands, following the introduction of their n... Read more
Prepare to be astounded at the versatility and broad range of features found in the AOR AR8200 Mark III. Unparalleled frequency coverage, superb sensi... Read more
After over a week of being hit by fast solar wind, conditions are finally beginning to calm down. We have had gorgeous aurora shows all over the world... Read more