Ameritron mobile no tune Solid State Amplifier
–Mobile no tune Solid State Amplifier – uses four rugged 2SC2879 high power linear RF power transistors.
–Instant bandswitching, no tuning, no warm up – just turn on and operate – makes mobile QSOs safer.
–Very Compact – Just 3 ½” x 9″ x 15″ – fits in nearly any mobile installation; weighs only 7 pounds.
–Extremely quiet – quiet low speed, low volume fan stays off and silent until temperature rises.
–Output Power – 500 watts PEP, 400 Watts CW
Continuous Coverage – 1.5 to 22 MHz 10/12 Meters with easy to install optional kit.
–Load Fault Protection – disables and bypasses amplifier if antenna has excessively h high reflected power or if bandswitching is set lower than exciter frequency – virtually eliminates damage because of operating error; has Load Fault LED indicator.
–Thermal Overload Protection – disables and bypasses amplifier if temperature is excessively high; automatically resets when temp drop to safe level Thermal Overload LED indicator.
–Excellent harmonic suppression – multiple section output network, push-pull output circuit has excellent harmonic suppression.
–DC current meter lets you monitor collector current.
–ON/OFF Switch – bypasses amplifier for “barefoot” operation without having to disconnect high current power supply cables.
–Remote ON/OFF Control – lets you remote control ON/OFF function for out-of-the-way mounting of amplifier.
–Exciter Drive – less than 100 watts input gives full output.
–Power Supply Requirements – requires 14 VDC at 80 amperes peak current for PA transistors and separate line for 14 – 16 VDC at 4 amperes for control and bias circuits. Made in USA.
$ 949.00 Each
A new “pre-release” version of WSJT-X now is available. This is the Amateur Radio digital software suite developed by Joe Taylor, K1JT, that includes... Read more
“An amazing new mode for quickly communicating around the world with low power and simple antennas. In this video Jim uses exterior holiday or C... Read more
Jim, W6LG tries FT8 using light bulbs as the antenna and communicates with another ham in Canada. The distance was 750 miles or about 1200km! This is... Read more
The TH-D74 is Kenwood’s latest hand held transceiver. It offers a wide range of features including digital (D-STAR), 2m/70cm analogue FM, APRS as well... Read more
The IC-R8600 is a new, advanced communication receiver with the capability of covering a huge range of radio spectrum from 10kHz to 3GHz as well as ha... Read more
Remote matching of antennas – less losses in the feed line. Designed for installation in a shack, under a shed, or in open (see mounting kit opt... Read more